September 17-20, 2018: Three EMC Short Courses by LearnEMC in Detroit, MI – 10% discount for IEEE members 🗓

from to
conference

September 17-20, 2018: Three EMC Short Courses by LearnEMC in Detroit, MI

Design for Automotive EMC Compliance – 9/17 & 9/18

Automotive Printed Circuit Board Layout – 9/19

Power Electronics Design for Electromagnetic Compatibility – 9/20

 Design for Automotive EMC Compliance

Details

Registration for September Short Courses

Price: $1195 (10% discount for IEEE members, use code IEEE-EMC at checkout)

 Date: September 17-18, 2018

Time: 8:00 am – 5:00 pm

Instructor: Dr. Todd Hubing, President of LearnEMC and past-president of IEEE EMC Society

This course stresses the fundamental concepts and tools that electronics engineers can employ to avoid electromagnetic compatibility and signal integrity problems in automotive systems. Students completing the course will be able to make good decisions regarding board layout and system design for EMC. They will also be introduced to tools and techniques for quickly reviewing designs in order to flag potential problems well before the first hardware is built and tested.

Automotive Printed Circuit Board Layout

Details

Registration for September Short Courses

Price: $595 (10% discount for IEEE members, use code IEEE-EMC at checkout)

Date: September 19, 2018

Time: 8:00 am – 5:00 pm

Instructor: Dr. Todd Hubing, President of LearnEMC and past-president of IEEE EMC Society

Printed circuit board layout is often the single most important factor affecting the electromagnetic compatibility of automotive systems. This course stresses the fundamental concepts and tools that board designers must be familiar with to meet automotive EMC requirements. Students completing the course will be able to make good decisions regarding component selection, component placement, and trace routing. In addition, students will have the knowledge and tools necessary to design effective power distribution and grounding strategies for automotive printed circuit boards.

 Power Electronics Design for Electromagnetic Compatibility

Details

Registration for September Short Courses

Price: $595 (10% discount for IEEE members, use code IEEE-EMC at checkout)

Date: September 20, 2018

Time: 8:00 am – 5:00 pm

Instructor: Dr. Todd Hubing, President of LearnEMC and past-president of IEEE EMC Society

This 1-day course covers fundamental and advanced design concepts related to the design of power electronic circuits for meeting electromagnetic compatibility requirements. In the morning session, basic power electronic circuit topologies and applications are reviewed with a focus on the fundamental properties of these circuits that result in unwanted conducted and radiated emissions. Noise source models are presented and various noise mitigation options are examined. The focus of the afternoon session is on advanced design concepts including grounding strategies, component selection and placement, and methods for maintaining electrical balance. Active noise cancellation techniques applicable in various situations are also presented. Finally, examples of good and bad power circuit designs ranging from low-voltage DC-to-DC converters to 700-volt electric vehicle motor drives are reviewed.